top of page

Maxxed Rize: Front Leak

If your marker has an air leak down the barrel. Check the items below. ​Reference the manual as needed. 

Issue:
Bolt:
  • Using a 1/4” allen key, remove your Rize bolt and replace the o-rings listed below either one section at a time, or all at once. Lube the Internal o-rings of the cylinder & cage with a generous amount of Dye slick lube. Outer sleeve o-rings should get only a small amount of lube.

  • Internal Bolt orings:

    • #2 - Cylinder Internal (Front): 017

    • #4 - Bolt Cage (Manifold) Internal: 014  (Note: If this was the bad o-ring, your input pressure might be too high)

  • Outer Bolt orings:

    • #1 - Cylinder Outer Sleeve: 020 (qty. 2)

    • #1 - Bolt Cage (Manifold) Outer Sleeve: 020

    • #1 - Rear Cap - Outer: 020 (x2) 

  • Remaining Bolt o-rings displayed for reference:

    • #4 - Bolt Tip: 014

    • #3 - Bolt Sail: 015

    • #6 - Rear Bumper:  13x2mm BN90

    • #5 - Bolt Stem: 009 (x2)

dmxr-bolt3.jpg
bottom of page